Designmaker

 Step 1: Front and back legs, as well as rings I didn't take nearly as many photographs as I should have in order to create a comprehensive guide . In any case, these are the key stages. Begin by utilising a bench power source to set the output voltage of the two converters. With a 9v input, the low voltage converter is programmed to produce 12v. Using a 12v input, the high voltage converter is adjusted to its maximum output voltage (about 210v). After that, wipe up the tube! To make soldering easier, I've cleaned and sanded the back connections. I began by shaping and welding the two brass rings that will be attached to the tube's ends. Then, using copper wire, I drew a preliminary drawing of the legs, establishing the general size. I sketched a leg shape and used it to create the front legs. A crude rig was used to build the front legs and front ring for soldering, as illustrated in the photo. The legs were then temporarily glued to a temporary wooden foundation, and the